TP08-05: The Application of Solid Water Treatment Chemistry for Cooling Towers Standards and Specifications

TP08-05: The Application of Solid Water Treatment Chemistry for Cooling Towers Standards and SpecificationsWater has become a precious commodity. Its per capita use in industrialized countrieshas increased dramatically over the past twenty five years. Its cost has increaseddramatically as well. Years ago, when equipment needed to be cooled, water was pumped out of a nearbywater source (such as a river, well or lake), went into a heat exchanger and was either putback into that water source or allowed to run off into a nearby stream. This is calledonce thru

35 mm) fill support tubes used in the tower were also harvested

Structural upgrades incorporated into the replacement tower design will also be discussed

reduced corrosion inhibitor feeds

people that water pollution abatement was serious business

Case histories will provide data on water and chemical treatment cost reductions as well as waste water reduction and improved cooling system protection

The updated standard document has removed any recommendations on surface finish

using the Merkel theory as analysis basis

Pitting corrosion rates obtained by potentiodynamic polarization techniques will be presented in addition to general corrosion rates obtained by linear polarization techniques

how it is applied

Finally a super low noise fan with special shape could only be accepted

represents an undue burden to the customer and may be technically unjustifiable

Due to the substantial costs associated with brine disposal